459 research outputs found
Modeling and Minimizing Spontaneous Raman Scattering for QKD Secured DWDM Networks
Quantum key distribution (QKD) provides\ua0information-theoretic security based on quantum mechanics. Integrating QKD with classical data traffic by using wavelength division multiplexing (WDM) techniques in a single fibre is a cost-efficient way to improve security in legacy infrastructure. In such a system, the main noise source to the quantum channel is spontaneous Raman scattering (SRS) caused by the classical channels. In this letter we introduce a channel allocation strategy for both quantum and classical signals to minimize the SRS noise. A use case that quantum and classical channels co-exist in a dense WDM system is investigated. The results show >26% increase of achievable transmission distance for the QKD system when implementing the introduced channel allocation strategy. Moreover, a network updating plan is proposed, which provides a guideline to light the new wavelengths for classical communications while minimizing the SRS noise to quantum channels
Recommended from our members
A portable device for studying the effects of fluid flow on degradation properties of biomaterials inside cell incubators.
A portable device was designed and constructed for studying the properties of biomaterials in physiologically relevant fluids under controllable flow conditions that closely simulate fluid flow inside the body. The device can fit entirely inside a cell incubator; and, thus, it can be used directly under standard cell culture conditions. An impedance-driven pump was built in the sterile flow loop to control the flow rates of fluids, which made the device small and portable for easy deployment in the incubator. To demonstrate the device functions, magnesium (Mg) as a representative biodegradable material was tested in the flow device for immersion degradation under flow versus static conditions, while the flow module was placed inside a standard cell incubator. The flow rate was controlled at 0.17 ± 0.06 ml/s for this study; and, the flow rate is adjustable through the controller module outside of incubators for simulating the flow rates in the ranges of blood flow in human artery (0.05 ∼0.43 ml/s) and vein (0.02 ∼0.08 ml/s). Degradation of Mg under flow versus static conditions was characterized by measuring the changes of sample mass and thickness, and Mg2+ ion concentrations in the immersion media. Surface chemistry and morphology of Mg after immersion under flow versus static conditions were compared. The portable impedance-driven flow device is easy to fit inside an incubator and much smaller than a peristaltic pump, providing a valuable solution for studying biomaterials and implants (e.g. vascular or ureteral stents) in body fluids under flow versus static conditions with or without cells
General Trinajstić Index
In memory of the outstanding theoretical chemist Nenad Trinajstić, Furtula introduced a new distance-based molecular structure descriptor "Trinajstić index" in chemical graph theory. In this paper, we propose the general Trinajstić index, and give the calculation formula of the general Trinajstić index for double-star graphs, double brooms, Kragujevac trees, firefly graphs and wheel graphs. As an application, we calculate the general Trinajstić index for some hydrocarbons
Marketing digital: a utilização das redes sociais como estratégia de empreendedorismo: estudo de caso b de b doces
Com o aumento do desemprego vivido pelo Brasil, muitos desempregados enxergam no empreendedorismo como uma saída para voltar ao mercado de trabalho, aumentando os números de empreendedores por necessidade. O presente estudo tem como objetivo descrever e analisar se o uso das redes sociais, Facebook e Instagram, e a ferramenta de comunicação WhatsApp, como ferramentas de Marketing Digital da empresa pesquisada são eficazes na conquista, comunicação e fidelização de clientes. Justifica-se, pois através de um estudo de caso procura mostrar aos empresários e a sociedade a importância e relevância do uso de redes sociais por pequenas e microempresas bem como do planejamento adequado para a sustentabilidade do
negócio
Nano-to-Submicron Hydroxyapatite Coatings for Magnesium-based Bioresorbable Implants - Deposition, Characterization, Degradation, Mechanical Properties, and Cytocompatibility.
Magnesium (Mg) and its alloys have shown attractive biocompatibility and mechanical strength for medical applications, but low corrosion resistance of Mg in physiological environment limits its broad clinical translation. Hydroxyapatite (HA) nanoparticles (nHA) are promising coating materials for decreasing degradation rates and prolonging mechanical strength of Mg-based implants while enhancing bone healing due to their osteoconductivity and osteoinductivity. Conformal HA coatings with nano-to-submicron structures, namely nHA and mHA coatings, were deposited successfully on Mg plates and rods using a transonic particle acceleration (TPA) process under two different conditions, characterized, and investigated for their effects on Mg degradation in vitro. The nHA and mHA coatings enhanced corrosion resistance of Mg and retained 86-90% of ultimate compressive strength after in vitro immersion in rSBF for 6 weeks, much greater than non-coated Mg that only retained 66% of strength. Mg-based rods with or without coatings showed slower degradation than the respective Mg-based plates in rSBF after 6 weeks, likely because of the greater surface-to-volume ratio of Mg plates than Mg rods. This indicates that Mg-based plate and screw devices may undergo different degradation even when they have the same coatings and are implanted at the same or similar anatomical locations. Therefore, in addition to locations of implantation, the geometry, dimension, surface area, volume, and mass of Mg-based implants and devices should be carefully considered in their design and processing to ensure that they not only provide adequate structural and mechanical stability for bone fixation, but also support the functions of bone cells, as clinically required for craniomaxillofacial (CMF) and orthopedic implants. When the nHA and mHA coated Mg and non-coated Mg plates were cultured with bone marrow derived mesenchymal stem cells (BMSCs) using the in vitro direct culture method, greater cell adhesion densities were observed under indirect contact conditions than that under direct contact conditions for the nHA and mHA coated Mg. In comparison with non-coated Mg, the nHA and mHA coated Mg reduced BMSC adhesion densities directly on the surface, but increased the average BMSC adhesion densities under indirect contact. Further long-term studies in vitro and in vivo are necessary to elucidate the effects of nHA and mHA coatings on cell functions and tissue healing
SOA pattern effect mitigation by neural network based pre-equalizer for 50G PON
Semiconductor optical amplifier (SOA) is widely used for power amplification in O-band, particularly for passive optical networks (PONs) which can greatly benefit its advantages of simple structure, low power consumption and integrability with photonics circuits. However, the annoying nonlinear pattern effect degrades system performance when the SOA is needed as a pre-amplifier in PONs. Conventional solutions for pattern effect mitigation are either based on optical filtering or gain clamping. They are not simple or sufficiently flexible for practical deployment. Neural network (NN) has been demonstrated for impairment compensation in optical communications thanks to its powerful nonlinear fitting ability. In this paper, for the first time, NN-based equalizer is proposed to mitigate the SOA pattern effect for 50G PON with intensity modulation and direct detection. The experimental results confirm that the NN-based equalizer can effectively mitigate the SOA nonlinear pattern effect and significantly improve the dynamic range of receiver, achieving 29-dB power budget with the FEC limit at 1e-2. Moreover, the well-trained NN model in the receiver side can be directly placed at the transmitter in the optical line terminal to pre-equalize the signal for transmission so as to simplify digital signal processing in the optical network unit
Enabling Technologies for Optical Data Center Networks: Spatial Division Multiplexing
With the continuously growing popularity of cloud services, the traffic volume inside the\ua0data\ua0centers is dramatically increasing. As a result, a scalable and efficient infrastructure\ua0for\ua0data\ua0center\ua0networks\ua0(DCNs) is required. The current\ua0optical\ua0DCNs using either individual fibers or fiber ribbons are costly, bulky, hard to manage, and not scalable.\ua0Spatial\ua0division\ua0multiplexing\ua0(SDM) based on multicore or multimode (few-mode) fibers is recognized as a promising technology to increase the\ua0spatial\ua0efficiency\ua0for\ua0optical\ua0DCNs, which opens a new way towards high capacity and scalability. This tutorial provides an overview of the components, transmission options, and interconnect architectures\ua0for\ua0SDM-based DCNs, as well as potential technical challenges and future directions. It also covers the co-existence of SDM and other\ua0multiplexing\ua0techniques, such as wavelength-division\ua0multiplexing\ua0and flexible spectrum\ua0multiplexing, in\ua0optical\ua0DCNs
To overcome the scalability limitation of passive optical interconnects in datacentres
We propose to add optical amplifier(s) to passive optical interconnect (POI) at top-of-rack in datacentres and validate this approach by introducing impairment constraints into POIs design. It is shown that one amplifier can improve scalability by a factor of 16
- …